Aruba Certified Mobility Expert V6.4 HPE6-A40 Dumps For Best Result – [2018 Dumps]

If you are in the hunt for a HPE6-A40 exam dumps material that will bring you closer to success, 640-864.org is here to provides help in HP Aruba Certified Mobility Expert 6.4 Written HPE6-A40 certification exam. For several years now, we are the leading provider of Aruba Certified Mobility Expert V6.4 HPE6-A40 exam questions for HP Aruba Certified Mobility Expert 6.4 Written HPE6-A40 Exam. we have served over 70,000 IT professionals and helped them achieve their goals.

Vendor HP
Exam Code HPE6-A40
Full Exam Name Aruba Certified Mobility Expert 6.4 Written
Certification Name Aruba Certified Mobility Expert V6.4
Technology

♥ 2018 Valid HPE6-A40 Dumps ♥

HPE6-A40 exam questions, HPE6-A40 PDF dumps; HPE6-A40 exam dumps: HPE6-A40 Dumps (60 Q&A) (New Questions Are 100% Available! Also Free Practice Test Software!)

Latest and Most Accurate HPE6-A40 Dumps:

Version: 8.0
Question: 1

Refer to the exhibit:
A network engineer review the HA redundancy configuration of the Master and Local controllers
shown in the exhibit.
The engineer notices HA preemption is not enabled.

A. The RAPs in the ap group of Cluster-A can failover to 10.10.10.1.2 and will start to fall back to
10.10.10.1 after 10.10.10.1 is up for 30 seconds.
B. The CAPs in the ap group of Cluster-A can failover to 10.10.10.1.2 and will start to fall back to
10.10.10.1 after 10.10.10.1 is up for 30 seconds.
C. The RAPs in the ap group of Cluster-A can failover to 10.10.10.1.3 and will start to fall back to
10.10.10.1 after 10.10.10.1 is up for 30 seconds.
D. The CAPs in the ap group of Cluster-A can failover to 10.10.10.1.3 and will not fallback the original
controller after 10.10.10.1 is up.

Answer: A

Question: 2

Refer to the exhibit:
A network support engineer tests the DHCP scopes design for a wireless network. The engineer finds
that clients connected to the Guest SSID not get the IP address as per the design. Guests that are
mapped to VLAN 1000 should get the IP address form the local controller’s DHCP. As per the
company policy, guests cannot get the IP form the controller DHCP.
Based on the information shown in the exhibit, what does the engineer need to do the correct this?

A. Change the VLAN 1000 subnet mask.
B. Change port GE0/0/0 to allow VLAN 1000.
C. Change the VLAN 1000 IP address.
D. Change the VLAN 1000 name and DHCP pool name so they are the same.

Answer: D

Question: 3

Refer to the exhibit:
An Aruba architect plans to design a network for a school with a single controller. Wired clients and
Aps on each floor are mapped to different VLAN. The VLAN mapping is shown in the exhibit. Dot1x
authentication is enabled for all the wireless clients, except. Guests, staff, and student users are
mapped to VLAN 200 and 201, respectively. Controller up-link and all other inter switch links are
trunk links and allow all necessary VLANs Aps and Based on the setup shown in the exhibit, which IP
configuration does the controller need?(Select two.)

A. RADIUS source interface
B. RADIUS source interface
C. IP helper address only on virtual interfaces of VLAN 200 and VLAN 201
D. IP helper address on all virtual interfaces of VLAN 101. 102,103,200 and 201
E. Static route to reach in the Data Center

Answer: AB

Question: 4

Refer to the exhibit:
A network is configured with one master controller, one active local controller, and one standby local
controller that use VRRP redundancy. All controllers are in the same data center. The customer wants
to configure AP termination redundancy in the event of controller failure and have the fastest
recovery.

A. Use 172.16.100.50 as the LMS-IP Group Building2 and 172.16.51 as the Backup LMS IP.
B. Use 172.16.100.52 as the LMS-IP Group Building2 and 172.16.51 as the Backup LMS IP.
C. Use 172.16.100.52 as the LMS-IP for AP GOUP Building 2.
D. Use 172.16.100.51 as the Backup LMS IP for AP Group building2.

Answer: D

Question: 5

An Aruba presales engineer works on a proof of concept (PoC) for a customer. As per the customer
requirements, RRAPs should be deployed at all home offices of employees who work from home.
Only traffic from the RAP in corporate subnets 172.16.10.0/24, 172.168.1.1/24, and 10.254.1.0/8
should reach the controller. The rest of the traffic should be processed by the local resources.
What is the recommended deployment design to meet these requirements?

A. Deploy the RAP in split-tunnel mode, and uses a firewall policy to forward traffic either locally or
to the corporate controller.
B. Deploy the RAP in CAP mode, and use a route map to forward traffic either locally or to the
corporate controller.
C. Deploy the RAP in split-tunnel mode, and use a route map to forward traffic either locally or to the
corporate controller.
D. Deploy the RAP in split-tunnel mode, and use the split tunnel networks to forward traffic either
locally or to the corporate controller.

Answer: C

Question: 6

Refer to the exhibit:
The ap spectrum local-override command is issued at the controller CLI, as shown in the exhibit.
What happens as a result?

A. All APs in the ap-group will be in spectrum mode on the 2.4GHZ and 5GHz radios.
B. All APs in the ap-group will be in spectrum mode on the 5GHz radios.
C. The AP225-1 will be in spectrum mode on the 5Ghz radio.
D. The AP225-1 will be in spectrum mode on the 2.4Ghz radio.

Answer: A

New Updated HPE6-A40 Exam Questions HPE6-A40 PDF dumps HPE6-A40 practice exam dumps: https://www.dumpsschool.com/HPE6-A40-exam-dumps.html